Standalone data logs to microSD / microSDHC card without a laptop.

USB 2.0 full-speed device (USB-A/Mini cable included).

OpenPort 2.0 J2534 Passthru Specifications:

TIS Techstream V8.30.023（We also provide the latest version of Tis Techstream）.

Tactrix Openport 2.0 is compatible work with Pcmtuner dongle (pcm-flash).

(We don't provide software and after-sale service support if you use other third-party software) The Openport can also be used as J2534 passthru for Mercedes Xentry Passthru, VW Audi Skoda ODIS, Subaru SSM4, Ford, Mazda software etc.OpenPort 2.0 EcuFlash software is capable of reflashing a large number of newer Subaru and Mitsubishi vehicles.Tactrix Openport 2.0 was excellently tested with Toyota, Ford, Mazda, Land rover, and Jaguar software.New PCB with inductance to increase voltage, suitable for tuning car under different voltages.New full chip new module plan, fast high speed transfer and very stable function.High Quality Full Chip Tactrix Openport 2.0+ECUFLASH J2534 ECU Chip Tuning Tool Highlights: Combined with our EcuFlash software, the OpenPort 2.0 is capable of reflashing a large number of newer Subaru and Mitsubishi vehicles, and support for other cars is in progress.New Full Chip New Module Plan,fast high speed transfer and very stable function.No Need worry dead any more after 1 or 2 times used.Problem Fixed.This is done to provide device and vehicle protection.

Note that when a 2.5mm plug is inserted into this jack, the OEM12 signal is not longer connected to pin 12 of the J1962 connector, only the internals of the Openport. The 2.5mm jack provides an easy way to connect to this pin outside of the J1962 connector. The 2.5mm jack Tip terminal is connected to the OEM12 functionality of the Openport 2.0, which means is can be used as an ADC voltage input, or a variable voltage or connection to ground can be applied to this teminal.This is typically used with Innovate MTS bus compatible devices such as a wide-band oxygen sensor, or similar devices from other manufacturers. The 2.5mm jack Ring and Sleeve terminals can be used to receive RS-232 data from another device.

In J1850VPW, only the J1850+ pin is used. In J1850PWM both the J1850+ and J1850- pins are used. (Support pending) Pins J1850+ and J1850- are used for SAE J1850 communications.Pins ISO-9141 K and ISO-9141 L are used for ISO-9141 and KWP2000 communications.Pins CANL and CANH are used for CAN and ISO15765 communications.The Openport 2.0 is not designed for 24 volt vehicles. Although the device can also be powered via USB, these need to be present for vehicle communications to occur. The Openport 2.0 is powered via the 12 volt Vbat and GND pins.

Coupon code tactrix openport 2.0